[rsrick]

I purchased on the cheap a 4/8 barber notch JR Torrey a while back. Scales were slightly warped and while not impeding the closing of the razor they were not aesthetically pleasing. Using many of the hints and tips posted throughout the forum, I decided to attempt making some scales. I am still not finished the process as seen in the pics but thought I would post where I am at so far. Constructive criticism more than welcome!

Scales are Honduras Rosewood, wedge was made from a piece of birch flooring that I had kicking around (I was looking for a contrasting wood) - will be redoing the wedge as it isn't fitting correctly due to sanding too much on the end, all brass hardware are from Micro Fasteners (which just arrived today!)

All was done using coping saw and hand sanding (while sitting in lawn chair having a beer or two ). I haven't decided on a finish yet ... may just go with a clear varathane or tung oil. Thoughts?

Preshot (second from right):



Post:

[icedog]

Nice job but I think the screw is a bit too long

[rsrick]

Oh come on now ... they're the perfect length .... hold the razor in display mode when not in use!

I'm not going to cut them down until I am happy with the scales.

[nurse42312]

hey, size is important..........
a good screw is vital.....

seriously looks good to me.

mark..........

[randydance062449]

They look far better than my first attempt! Yours are a keeper.

[rsrick]

I have finally got around to taking some pics of my finished scales. I used around five coats of glossy exterior spray-on Varathane. The blade was shave dull when I received it so this was also my first hone attempt.

I did my first full shave with it this morning. Edge can still use a bit of refining as it tugged in a few spots but overall I am happy with it.