Cleaning a safety razor

[jaro1069]

The reason I post on multiple forums is I want to get as much information as possible.

I was meaning no offense and I understand about wanting as much info as possible and I encourage that. I was just saying that it looks like most people have stated the same thing about how best to clean... It looks like vinegar isn't the preferable method... I mean if you have found a method that works for you then by all means continue to use it but these guys have been doing this a long time and if you are just starting then please try their advice first because they have already been through the trial and error phase and I would hate for any more stuff to get messed up because of the wrong method being used...( I hope that was written coherently as I just woke up and saw your post)

 

[jaro1069]

What about toothpaste and stuff like Scrubbing Bubbles? Are they too abrasive?

Use non bleach scrubbing bubbles during an initial cleaning phase after you get a razor.

 

[jaro1069]

For regular cleaning I don’t go any further than a soak with dish soap and water and a light scrubbing with a used toothbrush. I don’t want to use anything abrasive that will wear off the original plating.

When I have picked up razors at antique stores I’d use scrubby bubbles to soak the razor in, then scrub with a brush.

+1..

.

But remember to use a soft brush to avoid scratching

 

[jaro1069]

I think my main point was that most have said Don't use vinegar but you keep saying you want to use vinegar... Why the fascination with vinegar ? Like previously stated vinegar is an acidic substance and is not friendly with the finish of your razor or painted surfaces.

 

[Alex7]

Unfortunately I don't have Scrubbing Bubbles in my country(Romania).

 

[jaro1069]

Unfortunately I don't have Scrubbing Bubbles in my country(Romania).

Or an equivalent I forgot but looked and then remembered you stating you didn't have scrubbing bubbles in Romania back in 2017 and were told about CIF without bleach which was a European alternative

 

[jaro1069]

I mean do what works for you whether it's simply scrubbing or using an ultrasonic cleaner or whatever... Good luck. In going back to sleep now for a little while longer.. Its early here..

 

[Salamander]

My razors only need to be clearned once. Toothpaste and brush works wonders. On one I use daily, like a 1930's Schick, I rinse and wipe down. The brass stays nice and shiney.

 

[Lou Mowan]

If you have Barbasol it works nicely

 

[FredGeorge]

Any thoughts about an ultrasonic jewelry cleaner?

 

[Lou Mowan]

That would be worth a try I don't think it would hurt anything

 

[jaro1069]

That would be worth a try I don't think it would hurt anything

If you have pained numbers or other painted details you might have to touch up those because an ultrasonic cleaner can remove some painted surfaces and gold wash.. So use a bit of caution and short cycles to try to catch it before it does any damage.... I use one on new to me razors or if they are heavily gunked up.. If you have a TTO razor that's not opening or closing properly an ultrasonic cleaner can help remove build up that may be causing it to not work properly... Thrift stores are a good place to find inexpensive ultrasonic cleaners by the way....I found one that would normally cost about 100 dollars new for about 4 dollars...